I Nstallation - NEC Univerge SV8100 System Hardware Manual

3.2.2
4-26
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
Installation
To install a PZ-ME50 on the CD-CP00:
Do not remove or install the CD-CP00 with the power on.
For installation on the CD-CP00 blade refer to
with Daughter Boards Installed on page
This daughter board does not have any switches which need to be set and
does not require any hardware setting.
♦
Each node in a NetLink network requires the PZ-ME50.
♦
CD-CP00 without the PZ-ME50 installed, supports a
single chassis system only (Six slots only).
♦
CD-CP00 with the PZ-ME50 is required to support a
system with multiple chassis.
♦
CD-CP00 without the PZ-ME50 supports only (One)
CD-LTA (8 Digital Station/2SLT) blade.
♦
Failure to properly install and program ports higher
than 64 (as described below) can corrupt the SV8100
database. When the PZ-ME50 is not physically
installed on the CD-CP00, do not attempt to change
the PCPro database configuration to indicate that the
PZ-ME50 is installed on the CD-CP00, Program ports
64 and
configuration to the SV8100 system. This process can
cause the SV8100 database to be corrupted. Refer to
the
installation/programming procedure.
♦
To properly install and configure the PZ-ME50; first
install the PZ-ME50 on the CD-CP00. To program the
ports above 64 using PCPro, perform a new download
before attempting to program the ports.
♦
If the PZ-ME50 is installed on the CPU at a later date, a
system upgrade must be performed using the
CD-CP00 upgrade procedures. When a PZ-ME50 is
mounted on a CPU, all software upgrades are stored
on this daughter board. If the PZ-ME50 were to be
removed from the CPU, a software upgrade must be
performed to bring the CPU to the latest version.
4-15.
higher, and then
next bullet
Installing the SV8100 Blades
http//vietpro.com.vn
UNIVERGE SV8100
Figure 4-4 CD-CP00 Blade
upload the PCPro
for the proper