A Technical Specifications; Hardware Configuration; Leds - H3C WA2200 Series Installation Manual

A Technical specifications

Hardware configuration

This section describes the hardware configurations and functions of the WA2200 series.
The four models of the WA2200 series have different radio frequencies (RFs) and structures.
Table 5 lists the protocols that each model supports and their chassis materials.
Table 5 Supported protocols and chassis material
Type
Indoor
Outdoor
NOTE:
When the temperature is below –15°C, an outdoor AP starts the internal over-cold protection function,
and the power consumption increases 3 W to 5 W. When this happens, you must use an external PoE
module to supply power to the AP.
The WA2200 series APs have extraordinary radio frequency (RF) performance and provide
consummate service functions. With IP66 degree of protection, the outdoor models can be
directly deployed outdoors to simplify the installation. The models of the WA2200 series are
designed for application in various environments.

LEDs

The positions and identifications of LEDs on the panel vary by H3C model. For details about the
specific LEDs of indoor models, see Figure 31 and Table 6 For details about the LEDs on outdoor
models, see Table 6 Figure 32 Table 6 Figure 33 and Table 7
Model Protocols and chassis material
IEEE802.11a or IEEE802.11b/g,
WA2210-AG
plastic
IEEE802.11a + IEEE802.11b/g,
WA2220-AG
plastic
IEEE802.11b/g, waterproof cast
WA2210X-G
aluminum + plastic
IEEE802.11a + IEEE802.11b/g,
WA2220X-AG waterproof cast aluminum +
plastic
31
Power 802.3af PoE
consumption support
8 W Yes
10 W Yes
8 W Yes
10 W No