Work Sequence; Installing The Tcp/Ip Cable; Attaching The Hw Interface To The Image Intensifier - Siemens ARCADIS Orbic Installation And Startup Manual

Installation and settings
3-

Work sequence

2Installation and settings

Installing the TCP/IP cable

•
Plug the TCP/IP cross-over cable into the monitor trolley and into the 3D navigation
system (see figure below).
NOTE
Fig. 3:

Attaching the HW interface to the image intensifier

Fig. 4:
Siemens AG
Medical Solutions
If the ARCADIS system is connected to the navigation system via
the clinical network, there can be problems if the load on the clin-
ical network is heavy.
Plug
I.I._01
SPR2-320.814.03.02.02
06.05
Page 7 of 16
CS SD 24
7
0
0
0
ARCADIS Orbic