Parameterization With Starter - Siemens SINAMICS G120 Operating Instructions Manual

Commissioning (software)

5.6 Parameterization with STARTER

5.6 Parameterization with STARTER
Commissioning with STARTER
The following interfaces - which are Control Unit dependent available:
Table 5-15
Type
PC connected to CU
via
Interface
Restrictions
CU240S
CU240S DP
CU240S DP-F
General information for connecting STARTER
USS address: see P2011, default setting P2011 = 0
USS baudrate: see P2010, default setting P2010 = 8 (≙ 38400 baud)
PROFIBUS DP address: see P0918 or PROFIBUS DP DIP switches.
STARTER projects
Using STARTER either a new project can be created or an already existing project can be
opened.
To create a new project in STARTER one of the following methods can be used:
● Search inverter
● Wizard
● Select inverter.
When opening an existing project or creating a new project STARTER is in the offline mode.
To go online the button
Changing parameters with STARTER
Parameters can be changed online or offline (online preferred).
Online parameter changes are stored in the RAM of the inverter. A manual transfer from
RAM to EEPROM can be triggered by pressing
contents of the RAM and EEPROM are different, the user is asked whether or not they wish
to transfer the RAM data to the EEPROM.
5-16
Connection possibilities for STARTER
USS on RS232
PC Connection Kit
Option port
Peer to peer
X
X
X
has to be pressed.
USS on RS485
Sub D cable & RS485 to
RS232 converter
Sub D connector
Peer to peer
X
--
--
. When closing STARTER and the
Operating Instructions, 11/2006, A5E00766042B AA
PROFIBUS DP
DP interface
Sub D connector
up to 125 slaves
--
X
X
Control Units CU240S