Siemens SINAMICS G120 Operating Instructions Manual page 210

Functions
8.3 Digital inputs (DI)
Digital inputs and analog inputs used as digital inputs
Following digital inputs are available:
• CU240S and CU240S DP: DP P0701 ... P0709,
• CU240S DP-F:
Each digital input can be used as listed in the table below:
Table 8-5
Parameter
Value
0
1
2
3
4
9
10
11
12
13
14
15
16
17
18
25
27
29
33
99
Example
An ON/OFF1 command is to be accomplished using digital input DI0.
● P0700 = 2 Control enabled using the terminal strip (digital inputs)
● P0701 = 1 ON/OFF1 using digital input 0 (DI0).
8-14
P0712, P0713 analog inputs used as digital inputs
DP P0701 ... P0706,
P0712, P0713 analog inputs used as digital inputs
Possible settings of the digital inputs and analog inputs used as digital inputs
Significance
Digital input disabled
ON/OFF1
ON_REV/OFF1
OFF2 – coast to standstill
OFF3 – quick ramp-down
Fault acknowledge
JOG right
JOG left
Reverse
MOP up (increase frequency)
MOP down (decrease frequency)
Fixed frequency selector Bit 0
Fixed frequency selector Bit 1
Fixed frequency selector Bit 2
Fixed frequency selector Bit 3
Enable DC braking
Enable PID
External trip
Disable additional frequency setpoint
Enable BICO parameterization
Operating Instructions, 11/2006, A5E00766042B AA
Control Units CU240S