Parameterization With Mmc; Parameterization With Starter; Commissioning With Starter - Siemens SINAMICS CU240S DP-F Operating Instructions Manual

Commissioning (software)

2.5 Parameterization with MMC

2.5 Parameterization with MMC
Overview
A G120 inverter can be parameterized by downloading a parameter set from the MMC to the
inverter.
The download can be performed as
• manual download
• automatic download
• start-up download
A detailed download description can be found in the operation section.
2.6

Parameterization with STARTER

2.6.1

Commissioning with STARTER

Commissioning with STARTER
The following interfaces - which are Control Unit dependent are available:
Table 2-15
Type
PC connected to CU
via
Interface
Restrictions
CU240S
CU240S DP
CU240S DP-F
General information for connecting STARTER
USS address: see P2011, default setting P2011 = 0
USS baudrate: see P2010, default setting P2010 = 8 (≙ 38400 baud)
PROFIBUS-DP address: see P0918 or PROFIBUS-DP DIP switches.
2-14
Connection possibilities for STARTER
USS on RS232
PC Connection Kit
Option port
Peer to peer
X
X
X
USS on RS485
Sub D cable & RS485 to
RS232 converter
Sub D connector
up to 31 slaves
X
--
--
Operating Instructions (Compact), 04/2006, A5E00766042B AA
PROFIBUS DP
DP interface
Sub D connector
up to 125 slaves
--
X
X
Control Units CU240S