Siemens SINAMICS G120 Operating Instructions Manual page 147

Bit Value Meaning
0 Coast Stop activated
5 1 Quick Stop not activated
0 Quick Stop activated
6 1 Switching on inhibited
0 Switching on not inhibit
7 1 Warning present
0 No warning
8 1 Speed error within tolerance range
0 Speed error out of tolerance range
9 1 Master control requested
0 No control requested
10 1 Maximum frequency reached or
exceeded
0 Maximum frequency not reached
11 1 --
0 Warning: Motor at current/torque limit
12 1 Motor holding brake active
0 --
13 1 --
0 Motor overload
14 1 CW rotation
0 CCW rotation
15 1 --
0 Inverter overload
Control Units CU240S
Operating Instructions, 11/2006, A5E00766042B AA
5.9 Commissioning with PROFIBUS DP
Remarks
Coast Stop (OFF 2) command is present.
--
Quick Stop (OFF 3) command is present.
The drive goes only again in the "Switched On" condition
with "No Coast Stop AND No Quick Stop" followed by "ON".
--
Drive still works; warning in the service/maintenance para-
meter; no acknowledgement, see alarm parameter r2110.
There is no warning or the warning has disappeared again.
Setpoint/actual value deviation within tolerance range.
--
The automation system is requested to assume control.
The master is not currently the master control.
Inverter output frequency is higher or equal to the maximum
frequency.
--
--
--
Signal can be used to control a holding brake.
--
Motor data indicate overload condition.
--
--
--
--
e.g. current or temperature.
Commissioning (software)
5-91