Siemens SINAMICS G120 Operating Instructions Manual page 156

Commissioning (software)
5.9 Commissioning with PROFIBUS DP
Figure 5-17
PROFIsafe Parameters
The PROFIsafe parameters are shown in the following dialog box (to be opened eg. via left
mouse double click on PROFIsafe module).
Only the parameters
● F_Dest_Add: PROFIsafe address
● F_WD_Time: control time for the fail-safe functions
can be changed.
5-100
G120 inverter with fail-safe functions and a standard protocol in HW config of SIMATIC
S7
Operating Instructions, 11/2006, A5E00766042B AA
Control Units CU240S