Tool enables you to search by product, displaying all the transceivers supported on that device, or category,
by interface speed or type. The list of supported transceivers for the PTX1000 is located at
https://pathfinder.juniper.net/hct/product/#prd=PTX1000.
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
Cable and Connector Specifications for MX and PTX Series Devices
IN THIS SECTION
12-Fiber MPO Connectors | 60
24-Fiber MPO Connectors | 64
LC Duplex Connectors | 64
The transceivers that are supported on MX Series and PTX Series devices use fiber-optic cables and
connectors. The type of connector and the type of fiber depends on the transceiver type.
You can determine the type of cable and connector required for your specific transceiver by using the
Hardware Compatibility
Tool.
CAUTION:
cable.
NOTE:
The terms multifiber push-on (MPO) and multifiber termination push-on (MTP) describe
the same connector type. The rest of this topic uses MPO to mean MPO or MTP.
If you face a problem running a Juniper Networks device that uses a
To maintain agency approvals, use only a properly constructed, shielded
59