Drive Unit - Otto Bock Skippi Plus Service Manual

Service Work
For installation proceed as follows:
1. Remove the seat / seat plate.
2. Mount the seat module to the metal rail (item 1) using an Allen wrench, size 3.
3. Screw the metal rail in place using oval head screws / self-locking nuts (item 2).
4. Install and connect the seat module cables (for connections, see section 8.3).
Fig. 32 Retrofitting with seat module

6.13 Drive unit

Fenders
The coloured fenders are attached to the drive unit sustainer with three Allen head screws. For
tightening or loosening the screws use a size 3 Allen wrench.
Fig. 33 Remove the fender
Drive unit
To make the drive unit of the Skippi Plus accessible, first disconnect the cable from the control
panel and the cables of the front lights. Take care not to damage any cables when removing
the seat.
34 | Ottobock
2
1
Skippi Plus