Back - Otto Bock Skippi Plus Service Manual

Fig. 15 Loosening the rear screw connection of the seat
At the front, the seat is attached with the seat angle adjustment mechanism. Here, loosen the
seat at the bottom of the angle adjustment mechanism, which is attached to the frame. Loosen
the screw using a size 5 Allen wrench.
Once you have loosened all connections, you can remove the seat.
Lap belt
The lap belt of the Skippi Plus is/must be attached to the bearing plate. For attachment, an
attachment plate with eyelet is used. The mounting kit of the lap belt also includes spacer bush-
ings. Place these bushings between the eyelet and bearing plate. For tightening the screw use
a size 5 Allen wrench and a size 13 open-end wrench.
Fig. 16 Attaching the lap belt

6.7 Back

The back of the Skippi Plus is attached to the seat frame with two bearing plates on the left and
right. Each of the two bearing plates is attached to the seat frame with two screws and to the
back with one screw. For loosening these three screws, use a size 5 Allen wrench and a size
13 open-end wrench. Loosen the two screws on the seat frame on the left and right to remove
the back. The fourth screw on the bearing plate serves as stop for the back angle adjustment.
Skippi Plus
Service Work
Ottobock | 25