Otto Bock Skippi Plus Service Manual page 61

Menu tree
Input Devices
> Handcontrol Settings
> Drive
> Profile 1
> Turning speed (TurnSpeed)
Input Devices
> Handcontrol Settings
> Drive
> Profile 1
> Forward acceleration
(FwdAccel)
Input Devices
> Handcontrol Settings
> Drive
> Profile 1
> Forward deceleration (Fwd-
Decel)
Skippi Plus
enAble50 wheelchair control – installation and programming
Access Min. Max. De-
fault
Service 5 100
Service 5 100
Service 5 100
Unit
10 % Maximum turning speed
Determines the highest possible
turning driving speed at full deflection
when the position of the potentiometer
is set to maximum.
The turning speed is normally set to
a much lower value than the forward
driving speed.
If the position of the potentiometer
is between minimum and maximum,
the highest possible turning speed is
scaled linearly.
Ensure the user can operate the
wheelchair safely at the selected
speed.
20 % Maximum forward acceleration
Specifies the forward acceleration of
the wheelchair when the position of the
potentiometer is set to maximum.
A high value represents a short acce-
leration time and a fast start. High
acceleration values result in abrupt
speed changes and should only be
used in special cases.
If the position of the potentiometer is
between minimum and maximum, the
forward acceleration is scaled linearly.
Ensure the user can operate the
wheelchair safely at maximum accele-
ration.
20 % Maximum forward deceleration
Specifies the forward deceleration of
the wheelchair when the position of the
potentiometer is set to maximum.
A high value represents a short dece-
leration time and a rapid stop. High
deceleration values result in abrupt
speed changes and should only be
used in special cases.
If the position of the potentiometer is
between minimum and maximum, the
forward deceleration is scaled linearly.
Ensure the user can operate the
wheelchair safely at maximum decele-
ration.
Help text
Ottobock | 61