Otto Bock Skippi Plus Service Manual page 59

Hide thumbs Also See for Skippi Plus:
Table of Contents

Advertisement

Main
Menu
parameters
Reverse Beep
Timing
Motor & wheels
Seat
Brake
Actuators &
Servo
Driver outputs
Light
Reset distance
Reset hour meter
Skippi Plus
enAble50 wheelchair control – installation and programming
Submenu
A warning signal can be emitted during reverse
operation. It can be activated or deactivated in the
individual profiles.
Various delays can be programmed.
Auto
The wheelchair turns off after the established delay. It
shutoff
does not shut down if the setting is 0.
Drive timeout
Delay between the last driving command and auto-
matically switching to the prior mode. No switch if the
parameter is set to 0.
Aux timeout
Delay between the last input command and automati-
cally switching to the prior operating mode. No switch
if the parameter is set to 0.
Menu timeout
Defines the command time for menu operation.
Parameters that adapt the drive motors to the control-
ler. The direction of rotation can be changed.
Actuators
Parameters for adjusting the seat actuators (speed,
1 to 5
current).
The seat module offers a separate 12 volt output. The
voltage can be turned on or off under the "Miscellane-
ous" menu item.
Parameters that establish when the brakes engage
and disengage.
Two actuators (steering servos) are connected to the
controller. Speed and current values can be program-
Servo
med here, for example.
J1
J1–J3 are programmable outputs. Each of them is
designed for a 2 A load and set to battery +. Pro-
J2
grammable parameters:
J3
– Disable: Default setting. Output is not switched.
– External horn: Output activated by horn function.
– F an: Output activated when the programmed
controller temperature is reached.
– O vervoltage: Output activated when the program-
mable voltage is exceeded.
– Backward driving: Output activated during reverse
driving.
– S ystem on: Output activated when the system is
turned on.
Parameters for light and direction indicator settings
Trip and total kilometer readings can be reset.
Resets the hours of operation for the drive motors
Settings
Ottobock | 59

Advertisement

Table of Contents
loading

Table of Contents