Otto Bock Skippi Plus Service Manual page 23

Changing the position of the side panels
Side panel mounting brackets are located on the left and right sides of the seat frame. By loos-
ening the two set screws which are located on the underside, you can change the position of
the side panel.
Afterwards, retighten the set screws using a size 3 Allen wrench.
Fig. 12 Changing the position of the side panel
Setting and replacing the armrest pad
The arm pad of the side panel is attached with two set screws. After loosening these two set
screws, you can either change the position of the pad or completely remove it. The third set
screw is used for additionally clamping the armrest pad.
Fig. 13 Underside of the armrest and Changing the position
Lateral pads
The lateral pad is attached to the side panel with a hook and loop closure. For mounting, first
attach a hook and loop strip to the middle section of the side panel. Then press the hook and
loop strip of the lateral pad onto the side panel's hook and loop strip.
Skippi Plus
Service Work
Ottobock | 23