Pc Programming Station (Pcps); Programmable Parameters; Main Parameters - Otto Bock Skippi Plus Service Manual

Hide thumbs Also See for Skippi Plus:

Table of Contents

8.5.2 PC programming station (PCPS)

The enAble50 control unit can also be programmed with the 1314 PCPS programming station.

In addition to the programming software, an interface is required to connect the computer and

control unit. An adapter is required to programme the enAble50 wheelchair control unit. Article

no. 493U32=SK185 includes the programming software, interface and adapter cable.

INFORMATION

For more information on using the software, please see the enAble50 instructions for use (reference

number 647G490=D/GB).

WARNING

Risk of accidents and injury due to incorrect configuration settings. Modified parameter settings in

the configuration can lead to changes in driving characteristics. In particular, changes to the speed,

acceleration, wheel lock or joystick settings can lead to unexpected and therefore uncontrollable driv-

ing characteristics and cause an accident.

Always test the driving characteristics of the power wheelchair after configuration/programming is

complete.

Programming may only be performed by qualified, trained personnel. Neither Ottobock nor the control

unit manufacturer are liable for damages (especially in combination with special controls) caused by

programming that was not properly/professionally adapted to the abilities of the wheelchair user.

INFORMATION

An overview of the adjustable parameters is described here. For detailed descriptions of the parameters,

please see the enAble50 instructions for use (reference number 647G490=D/GB).

The enAble50 wheelchair control unit includes a number of parameters that can be programmed

using the handheld programming device or the 1314 PCPS (see section 8.5). These program-

mable parameters allow the driving characteristics and performance of the vehicle to be adapted

to the specific requirements of the user. Information on the use of the handheld programming

device can be found in section 8.5.1.

The menu tree is divided into the following three main parameters:

U Input Devices

U System Settings

U Configuration.

Skippi Plus

enAble50 wheelchair control – installation and programming

Ottobock | 57

Table of Contents