Seat Module; Connecting The Seat Module - Otto Bock Skippi Plus Service Manual

8.3 Seat module

The seat module is attached to the wheelchair with two screws (see section 6.7).
1
3
Fig. 58 Seat module connection diagram
1 IN-A, IN-B, IN-C, IN-D, IN-E connections
2 RSW
3 A1–A5 connections (actuators A1–A5)
4 BUS connection
5 BUS connection
6 12 V DC (connection must be activated by parameter -> On/Off!)

8.3.1 Connecting the seat module

The following figure shows how to wire the seat module. The power supply for the seat module
is supplied via the bus.
Fig. 59 Seat module connection diagram
Skippi Plus
2
4 5 6
enAble50 wheelchair control – installation and programming
Ottobock | 53