Seat - Otto Bock Skippi Plus Service Manual

Service Work

6.6 Seat

Both, the seat depth and seat width of the Skippi Plus seat can be individually adapted to the
child.
Adjusting the seat width
The side panels are used to set the seat width (see section 6.5 Side Panel). There are two coun-
tersunk head screws on each side panel attachment device, below the seat surface. Loosen
these two screws using an Allen wrench. Set the appropriate seat width. The adjustment is
continuous. After adjustment, snugly retighten the countersunk head screws.
Adjusting the seat depth
The seat depth of the Skippi Plus is continuously adjustable from 300 mm to 370 mm/11,8" to
14,6". To adjust the seat depth, loosen the two individual screws on the left and right of the seat
frame's front end. For loosening these screws you need an Allen wrench. Once you have loos-
ened these two screws, you can pull out the front part of the seat frame to the front and fix it in
the desired seat depth position. The adjustment is continuous. Only the first bore hole is used
for fixing the frame part.
Make sure that the square nut inside the tube remains in position.
Fig. 14 Loosening the screw and Adjusting the seat depth
Replacing the seat
The entire seat of the Skippi Plus can easily be disassembled for removal or replacement. Make
sure to first disconnect the control cable to avoid damaging the cables and plug connections.
At the rear, the seat is secured with one screw connection on each side, left and right. Use two
size 5 Allen wrenches to loosen these screw connections.
24 | Ottobock Skippi Plus