Otto Bock Skippi Plus Service Manual page 18

Service Work
Fig. 5 Standard holder and Swing-away in parallel
The control panel holders for the Skippi Plus are attached to the armrest, beneath the armrest
pad. To mount or replace a control panel holder, first remove the control panel and deposit it on
the floor. Next, take the side panel out of its holding device. After loosening the three set screws,
you can either change the position of the control panel holder or completely remove it.
The two control panel holders are attached in the same way to the side panel of the Skippi Plus.
They are clamped to the underside of the armrest pad with an iron rail.
Attendant control
The attendant control for the Skippi Plus can only be mounted in combination with the height-
adjustable push handles.
The control is attached to the upper end of the push handle: cut a hole in the end of the rubber
hand grip and insert the holder for the attendant control into this hole.
Then tighten the screw connection on the holder using a size 5 Allen wrench.
Lead the cable of the control along the push handle downwards to the control box. Use cable
ties to fix the cable at certain intervals.
Fig. 6 Attendant control on the push handle
18 | Ottobock Skippi Plus