Otto Bock Skippi Plus Service Manual page 38

Service Work
Rear lights
The rear lights are attached to the rear side of the drive unit sustainer with two holders.
The holders are attached with two oval head screws.
These screws are put through from the inside to the outside and secured with two lock nuts.
Replacing defective lamps
NOTICE
Damage to the bulb. If possible, use a piece of cloth when inserting the bulb to avoid direct
contact.
Replacing the LED headlight
The LED headlight has to be disconnected from the wiring and removed from the holder as a
complete unit. All components must be properly reassembled after replacement.
Replacing the front direction indicator
For replacing the front direction indicators, it is best to use a small flathead screwdriver.
Slightly press into the notch on top of the housing until the nose jumps out.
Turn the bulb a quarter turn counter-clockwise and remove it. If possible, use a piece of cloth
when inserting the bulb to avoid direct contact.
Fig. 39 Loosening the protective glass of the direction indicator; Replacing the front direction indicator
When installing the lamp, make sure that the lamp's noses engage in the socket's notches and
turn the lamp a quarter turn clockwise to fix it in place.
Now remount the protective glass: Insert the lower nose in the notch and let the upper nose
engage with light pressure.
Replacing the rear light with direction indicator
Loosen the 2 Phillips head screws and remove the glass cover. Now you can pull the respective
lamp forward out of the socket and replace it.
Properly reassemble all components upon termination of the work. During installation of the
lamps, ensure that the lug on the lamp engages in the notch on the socket. Ensure the glass
covers are seated properly in the housing when installing them. Tighten the screws on the glass
cover firmly so that moisture cannot penetrate into the lamp.
38 | Ottobock Skippi Plus