Table of Contents
Advertisement
7.17.1
T ool Operation – Servo On/Off
1 1 5 B
Turn the servo on to make the motor be in the state that the servo is locked first in the operation of the
servo motor.
Therefore, in the tool operation, set the servo to ON using this setting.
1. Click [Servo ON/OFF] in Tool operation dialog. The following dialog is shown.
2. Set the servo to on/off by clicking the [Change ON/OFF] for the equivalent axes.
If the servo is on for the 1 axis to 3 axis, the setting is as below.
3. Click [Close] to close this dialog after completing the servo ON for the axes operated in the
tool operation. The tool operation dialog is automatically shown once the dialog is closed.
Note:
If the servo ON/OFF has been controlled using the ladder program before starting the tool operation, the
state of the servo lock/servo free is also kept in the tool operation.
7-40
Advertisement
Table of Contents
