Table of Contents
Advertisement
14−18
Upward
Upward
Notch
SST (B)
Magnetic
Finger
1CD−FTV ENGINE REPAIR MANUAL (RM1046E)
ENGINE MECHANICAL
44.
(a)
Cam Lobe
(b)
Clearance
A09687
(c)
(d)
A87966
45.
(a)
Cam Lobe
Intake
Manifold
Side
A88503
SST (A)
HINT:
Use SST (B) marked with "11".
A62959
A09615
−
PARTIAL ENGINE ASSY (1CD−FTV)(From September,
2003)
INSPECT VALVE CLEARANCE
Turn the crankshaft so that the cam lobe located over the
inspecting valve faces upward.
Using a feeler gauge, measure the clearance between
the valve lifter and camshaft.
Measure the clearance at 16 places.
Record the out−of−specification valve clearance mea-
surements. They will be used later to select an adjusting
shim to replace.
Valve clearance (Cold) :
Intake
0.20 to 0.30 mm (0.008 to 0.012 in.)
Exhaust
0.35 to 0.45 mm (0.014 to 0.018 in.)
ADJUST VALVE CLEARANCE
Remove the adjusting shim.
(1)
Turn the crankshaft so that the cam lobe located
over the adjusting valve faces upward.
(2)
Position the notch of the valve lifter toward the in-
take manifold side.
(3)
Using SST (A), press down the valve lifter, then
place SST (B) between the camshaft and valve lift-
er. Remove SST (A).
SST
09248−55050 (09248−05510, 09248−05520)
(4)
Remove the adjusting shim using a small screwdriv-
er and magnetic finger.
Advertisement
Table of Contents
