Table of Contents
Advertisement
8
16
13
2
10
18
4
12
17
14
15
6
Pry
SST
1CD−FTV ENGINE REPAIR MANUAL (RM1046E)
ENGINE MECHANICAL
16.
5
(a)
11
3
NOTICE:
Removing the bolts in a wrong order could cause warpage
or cracks of the cylinder head.
9
1
7
A09566
(b)
HINT:
To lift the cylinder head, pry between the cylinder head and cyl-
inder block using a screwdriver.
NOTICE:
Be careful not to damage the contact surfaces of the cylin-
der head and cylinder block.
A09563
17.
(a)
A56695
(b)
NOTICE:
Be careful not to damage the No. 1 and No. 2 oil pans.
SST
B08601
18.
(a)
A56696
−
PARTIAL ENGINE ASSY (1CD−FTV)(From September,
2003)
REMOVE CYLINDER HEAD SUB−ASSY
Using several steps, loosen the 18 cylinder head bolts
uniformly in the sequence shown in the illustration. Re-
move the 18 cylinder head bolts and plate washers.
Lift the cylinder head from the dowels on the cylinder
block, then place the cylinder head on wooden blocks on
a work bench.
REMOVE OIL PAN SUB−ASSY NO.2
Remove the 16 bolts and 3 nuts.
Insert the blade of SST between the No. 1 and No. 2 oil
pans, then cut off the applied sealer and remove the No.
2 oil pan.
SST
09032−00100
REMOVE OIL STRAINER SUB−ASSY
Remove the 2 bolts and 2 nuts, then remove the oil strain-
er and gasket.
14−7
Advertisement
Table of Contents
