Cli Example 2: Configure Exec Authorization By A Radius Server - NETGEAR M4200 Software Administration Manual

CLI Example 2: Configure EXEC Authorization by a RADIUS
Server
The following example shows how to use the CLI to configure command authorization by a
RADIUS server for a Telnet user and allow the user to access privileged EXEC mode directly.
1. Configure a RADIUS server on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#radius server host auth 172.26.2.41
(Netgear Switch) (Config)#radius server key auth 172.26.2.41
Enter secret (64 characters max):12345678
Re-enter secret:12345678
2. Change the authentication mode for Telnet users to RADIUS.
(Netgear Switch)(Config)#aaa authentication login networkList radius
3. Verify that the RADIUS authentication is set up for Telnet users.
(Netgear Switch) #show authentication methods
Login Authentication Method Lists
---------------------------------
defaultList :
networkList :
Enable Authentication Method Lists
----------------------------------
enableList :
enableNetList :
Line Login Method List
------- -----------------
Console defaultList
Telnet networkList
SSH networkList
HTTPS :local
HTTP :local
DOT1X :
4. Create an EXEC authorization list and configure RADIUS as the authorization.
(Netgear Switch)(Config)# aaa authorization exec execList radius
Managed Switches
local
radius
enable none
enable none
Enable Method List
------------------
enableList
enableList
enableList
Security Management
362