NETGEAR M4200 Software Administration Manual page 515

The settings for VLAN ID 1002 display in the fields in the table heading.
c. In the Priority field, enter 0.
d. Click Apply.
Web Interface: Configure PVSTP on Switch 2
1. Ensure that ports 1/0/1 and 1/0/2 are in VLAN 1002 in tagged mode because BPDU
packets for PVSTP are transmitted in tagged packets.
2. Enable PVSTP.
a. Select Switching > STP > Basic > STP Configuration.
A screen similar to the following displays.
b. Configure the following settings:
• For Spanning Tree Admin Mode, select the Enable radio button.
• For Force Protocol Version, select the PVST radio button.
c. Click Apply.
Note: After you enable PVST globally, PVST is applied to VLANs automatically.
3. Display the PVST status for ports 1/0/1 and 1/0/2 in VLAN 1002.
a. Select Switching > STP > Advanced > PVST Interface.
A screen similar to the following displays.
Managed Switches
STP
515