NETGEAR M4200 Software Administration Manual page 619

3. Create a routing interface connecting to the client.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#Interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 10.200.1.1 255.255.255.0
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#interface 1/0/16
(Netgear Switch) (Interface 1/0/16)#routing
(Netgear Switch) (Interface 1/0/16)#ip address 10.200.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/16)#exit
4. Configure the DHCP Server IP address and enable the DHCP L3 relay.
(Netgear Switch) (Config)#ip helper-address 10.100.1.1 dhcp
(Netgear Switch) (Config)#ip helper enable
Web Interface: Configure a DHCP L3 Relay
1. Enable routing mode on the switch.
a. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Create a routing interface and assign 10.100.1.2/24 to it.
a. Select Routing > IP > Advanced > IP Interface Configuration.
Managed Switches
DHCP L2 Relay and L3 Relay
619