Static Mapping; Cli: Configure Static Mapping - NETGEAR M4200 Software Administration Manual

6. Configure port 1/0/1 as trusted.
a. Select Security > Control > Dynamic ARP Inspection > DAI Interface
Configuration.
b. Select the Interface 1/0/1 check box.
c. For the Trust Mode, select Enable.
d. Click Apply.
A screen similar to the following displays.
Now ARP packets from the DHCP client will go through; however ARP packets from the
static client are dropped, since it does have a DHCP snooping entry. It can be overcome by
static configuration as described in the following section,

Static Mapping

The example is shown as CLI commands and as a web interface procedure.

CLI: Configure Static Mapping

1. Create an ARP ACL.
(Netgear Switch) (Config)# arp access-list ArpFilter
2. Configure the rule to allow the static client.
(Netgear Switch) (Config-arp-access-list)# permit ip host 192.168.10.2
mac host 00:11:85:ee:54:e9
3. Configure ARP ACL used for VLAN 1.
(Netgear Switch) (Config)# ip arp inspection filter ArpFilter vlan 1
Managed Switches
Security Management
337
Static Mapping on page 337.