Show Mac-Address-Table Igmpsnooping; Cli For Igmpv1 And Igmpv2: Show Mac-Address-Table Igmpsnooping; Cli For Igmpv3: Show Igmpsnooping Ssm Entries - NETGEAR M4200 Software Administration Manual

Show mac-address-table igmpsnooping

The example is shown as CLI commands and as a web interface procedure.
CLI for IGMPv1 and IGMPv2: Show mac-address-table
igmpsnooping
(Netgear Switch) #show mac-address-table igmpsnooping ?
<cr>
(Netgear Switch) #show mac-address-table igmpsnooping
-----------------------
00:01:01:00:5E:00:01:16
00:01:01:00:5E:00:01:18
00:01:01:00:5E:37:96:D0
00:01:01:00:5E:7F:FF:FA
00:01:01:00:5E:7F:FF:FE

CLI for IGMPv3: show igmpsnooping ssm entries

(Netgear Switch) #show igmpsnooping ssm entries
VLAN
ID Group
---- ---------------------- ---------------------- ----------- --------------
1000 224.1.1.1
Managed Switches
Press Enter to execute the command.
Type Description
------- --------------
Dynamic Network Assist
Dynamic Network Assist
Dynamic Network Assist
Dynamic Network Assist
Dynamic Network Assist
Source Ip
1.1.1.1
IGMP Snooping and Querier
281
Interfaces
-----------
Fwd: 1/0/47
Fwd: 1/0/47
Fwd: 1/0/47
Fwd: 1/0/47
Fwd: 1/0/47
Source
Filter Mode Interfaces
include 1/0/2