Web Interface: Configure One-Way Access Using A Tcp; Flag In An Acl - NETGEAR M4200 Software Administration Manual

3. Create VLAN 200 with port 1/0/48 and assign IP address 192.168.200.1/24.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 200
(Netgear Switch) (Vlan)#vlan routing 200
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#vlan pvid 200
(Netgear Switch) (Interface 1/0/48)#vlan participation include 200
(Netgear Switch) (Interface 1/0/48)#exit
(Netgear Switch) #interface vlan 200
(Netgear Switch) (Interface-vlan 200)#routing
(Netgear Switch) (Interface-vlan 200)#ip address 192.168.200.2 255.255.255.0
(Netgear Switch) (Interface-vlan 200)#exit
4. Add two static routes so that the switch forwards the packets with destinations
192.168.100.0/24 and 192.168.30.0/24 to the correct next hops.
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip route 192.168.100.0 255.255.255.0 192.168.200.1
(Netgear Switch) (Config)#ip route 192.168.30.0 255.255.255.0 192.168.200.1

Web Interface: Configure One-Way Access Using a TCP

Flag in an ACL

This is a two-part process:
• Configuring VLAN and IP addresses on switch A
• Configuring the Switch B
Configuring VLAN and IP addresses on switch A
1. Create VLAN 30 with IP address 192.168.30.1/24.
a. Select Routing > VLAN > VLAN Routing Wizard.
A screen similar to the following displays.
Managed Switches
on page 181
ACLs
173
on page 173