b. In the VLAN ID field, enter 2000.
c. In the VLAN Type field, select Static.
d. Click Add.
2.
Add ports to VLAN 2000.
a. Select Switching > VLAN > Advanced > VLAN Membership.
A screen similar to the following displays.
b. In the VLAN ID list, select 2000.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 1 and 24 until U displays.
The U specifies that the egress packet is untagged for the port.
e. Click Apply.
3.
Set force authorized mode on ports 1/0/6 and 1/0/12.
a. Select Security > Port Authentication > Advanced > Port Authentication.
A screen similar to the following displays.
b. Scroll down and select the Interface 1/0/6 and 1/0/12, check boxes.
c. In the Control Mode list, select Force Authorized.
d. Click Apply to save settings.
4.
Enable dot1x on the switch.
Make sure that 1/0/12 and 1/0/6 are configured as force authorized before you do this
step; otherwise you cannot access the switch through the Web Interface.
a. Select Security > Port Authentication > Basic > 802.1x Configuration.
Managed Switches
Security Management
324