Example #3: Configure Isolated Vlans On A Layer 3 Switch By Using Acls - NETGEAR 7000 Series Administration Manual
Netgear managed switch administration guide
Hide thumbs
Also See for 7000 Series:
- Administration manual (344 pages) ,
- Installation manual (2 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
5. Create a static route with IP address 192.168.30.0/24:
a. From the main menu, select Routing > Routing Table > Basic > Route Configuration. A
screen similar to the following displays.
Figure 9-21
b. Under Configure Routes, make the following selection and enter the following
information:
•
Select Static from the Route Type pulldown menu.
•
In the Network Address field, enter 192.168.30.0.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Next Hop IP Address field, enter 192.168.200.1.
c. Click Add.
Example #3: Configure Isolated VLANs on a Layer 3 switch by
Using ACLs
This example shows how to isolate VLANs on a Layer 3 switch by using ACLs. In this example,
PC1 is in VLAN 24, PC2 is in VLAN 48, and PC3 is in VLAN 38. PC1 and PC2 are isolated by an
ACL but can both access the server.
Access Control Lists (ACLs)
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
v1.0, May 2008
9-23
Advertisement
Table of Contents
