Configure Multiple Stp (802.1S); Cli: Configure Multiple Stp (802.1S) - NETGEAR M4200 Software Administration Manual

Configure Multiple STP (802.1s)

The example is shown as CLI commands and as a web interface procedure.

CLI: Configure Multiple STP (802.1s)

(Netgear switch) (Config)# spanning-tree
(Netgear switch) (Config)# spanning-tree mode mst
(Netgear Switch) (Config)#spanning-tree configuration name mstp_1
(Netgear Switch) (Config)#spanning-tree configuration revision 0
Configure an MSTP region name and revision for the switches in the same MSTP region.
The switches in the same MSTP region must be configured with the same region name
and revision.
Create a mst instance 1:
(Netgear switch) (Config)# spanning-tree mst instance 1
Associate the mst instance 1 with the VLAN 2 and 3:
(Netgear switch) (Config)# spanning-tree mst priority 1 4096
(Netgear switch) (Config)# spanning-tree mst vlan 1 2
(Netgear switch) (Config)# spanning-tree mst vlan 1 3
Create a mst instance 2:
(Netgear switch) (Config)# spanning-tree mst instance 2
Associate the mst instance 2 with the VLAN 11 and 12:
(Netgear switch) (Config)# spanning-tree mst priority 2 4096
(Netgear switch) (Config)# spanning-tree mst vlan 2 11
(Netgear switch) (Config)# spanning-tree mst vlan 2 12
Configure the priority and cost on port 1/0/3:
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 port-priority 128
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 cost 0
Managed Switches
STP
506