Cli: Configure Pvstp - NETGEAR M4200 Software Administration Manual

The following diagram shows a simple PVSTP configuration.
1/0/1
Switch 1
1/0/2
Figure 54. PVSTP configuration

CLI: Configure PVSTP

You must configure PVSTP on Switch 1 and Switch 2. This example assumes that all
switches can support PVSTP.
CLI: Configure PVSTP on Switch 1
1. Ensure that ports 1/0/1 and 1/0/2 are in VLAN 1002 in tagged mode because BPDU
packets for PVSTP are transmitted in tagged packets.
2. Enable PVSTP.
(Netgear Switch) #config
(Netgear Switch) (Config)#spanning-tree mode pvst
Note: After you enable PVSTP (or PVRSTP) globally, PVSTP (or PVRSTP)
is applied to VLANs automatically.
Managed Switches
1/0/1
Switch 2
1/0/2
STP
510