Add Acl Remarks - NETGEAR M4200 Software Administration Manual

4. Bind the ACL with interface 1/0/1.
a. Select Security > ACL > Advanced > IP Binding Configuration.
A screen similar to the following displays.
b. In the Sequence Number field, enter 1.
c. In the Port Selection Table, click Unit 1 to display all the ports.
d. Select the check box below Port 1.
e. Click Apply.

Add ACL Remarks

You can use the remark keyword to include comments (remarks) for ACL rule entries in a
MAC or IP ACL. Remarks can help you and other users to understand ACL rules. Each
remark line is limited to 100 characters. Remarks can consist of characters in the range A–Z,
a–z, and 0–9 and of special characters such as spaces, hyphens, and underscores. If you
want to create remarks for a permit or deny rule, you must create the remarks before you
create the rule. If you remove a rule, all associated remarks are removed as well. If remarks
are no longer applicable, you can remove them. You can also add remarks to a MAC or IP
ACL without adding any rules, save the remarks, and add the rules later.
The following example shows how you can add remarks to rules:
1. Create an ACL.
(Netgear Switch) (Config)#ip access-list acl_voice
2. Add a remark before you add a rule.
(Netgear Switch) (Config-ipv4-acl)#remark "permit VOIP packets whose DSCP is EF"
(Netgear Switch) (Config-ipv4-acl)#permit ip any any dscp ef
(Netgear Switch) (Config-ipv4-acl)#remark "deny all of other packets" (Netgear Switch)
(Config-ipv4-acl)#deny ip any any
(Netgear Switch) (Config-ipv4-acl)#exit
(Netgear Switch) (Config)#exit
Managed Switches
ACLs
209