NETGEAR M4200 Software Administration Manual page 175

A screen similar to the following displays.
b. Enter the following information:
• In the Vlan ID field, enter 200.
• In the IP Address field, enter 192.168.200.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 44 twice until U displays.
The U specifies that the egress packet is untagged for the port.
e. Click Apply to save VLAN 200.
4. Enable IP routing.
a. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
b. Under IP Configuration, make the following selections:
• For Routing Mode, select the Enable radio button.
• For IP Forwarding Mode, select the Enable radio button.
c. Click Apply to enable IP routing.
Managed Switches
ACLs
175