Enable Rip On The Switch; Cli: Enable Rip On The Switch; Web Interface: Enable Rip On The Switch - NETGEAR M4200 Software Administration Manual

Enable RIP on the Switch

Note: Unless you have previously disabled RIP, you can skip this step since
RIP is enabled by default.

CLI: Enable RIP on the Switch

This sequence enables RIP for the switch. The route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit

Web Interface: Enable RIP on the Switch

1. Select Routing > RIP > Basic > RIP Configuration.
A screen similar to the following displays.
2. For RIP Admin Mode, select Enable radio button.
3. Click Apply to save the setting.
Managed Switches
RIP
93