Add Or Change The Name Label For A Port - NETGEAR MS108EUP User Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
The PORT STATUS pane displays on the right or the bottom of the HOME page,
depending on the size of your browser window.
A port that is in use shows as CONNECTED. A port that is not in use shows as
AVAILABLE.
4. Select the port.
The pane displays port settings.
5. Select one of the following options from the Speed menu:
• Auto: The port speed is set automatically after the switch determines the speed
using autonegotiation with the linked device. This is the default setting.
• Disable: The port is shut down (blocked).
• 100M Full: The port is forced to function at 100 Mbps with full-duplex.
• 1G Full: The port is forced to function at 1 Gbps with full-duplex.
• 2.5G Full: The port is forced to function at 2.5 Gbps with full-duplex.
6. Click the APPLY button.
Your settings are saved.

Add or change the name label for a port

You can add or change a name label for a port. Name labels are for your reference only,
and do not affect port behavior.
To add or change a name label for a port:
1. Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The password is the one that you specified the first time that you logged in. The
password is case-sensitive.
The HOME page displays.
Optimize the Switch
Performance
30 User Manual