Config Acl Rule Match Srcl4Port Keyword; Config Acl Rule Match Srcl4Port Range; Config Acl Interface Add - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config acl rule match srcl4port keyword

This command specifies a source layer 4 port match condition for an ACL rule referenced by the
and
<aclid> <rulenum>
values of
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp
these values translates into its equivalent port number, which is used as both the start and end of
the port range.
This command and the
specifying the source layer 4 port range as a match condition. Either command can be used to
configure or modify the source layer 4 port range.
Format
config acl rule match srcl4port keyword <aclid> <rulenum> <portkey>

config acl rule match srcl4port range

This command specifies a packet's source layer 4 port match condition for an ACL rule referenced
by the and
<aclid> <rulenum>
and last ports that are part of the port range and have values from 0 to 65535. The ending port must
have a value equal or greater than the starting port. The starting port, ending port, and all ports in
between will be part of the contiguous source port range.
Either the this command or
source layer 4 port range as a match criterion.
Format config acl rule match srcl4port range <aclid> <rulenum> <startport>
<endport>

config acl interface add

This command associates an ACL with an interface in the specified direction. The
parameter can have the values of
Format config acl interface add <slot.port> <direction> <aclid>
ACL Commands
. The uses a single keyword notation and has the possible
<portkey>
config acl match srcl4port range
. The
<startport>
config acl match srcl4port keyword
or . The
in out
202-10009-01
command are two methods of
and parameters identify the first
<endport>
parameter specifies the ACL to add.
<aclid>
, and . Each of
www
can be used to specify a
<direction>
10-7