ENGINE DISASSEMBLY / INSPECTION -
TOP END
VALVE COVER REMOVAL
NOTE
The valve cover, camshafts, cylinder head, cylinder and
piston can be serviced with the engine installed in the
chassis.
1. If needed, remove the spark plug wire from the
engine.
2. Remove dirt and debris from valve cover area.
3. Remove the four valve cover bolts
4. Carefully lift valve cover from the engine and remove
it out of the right-hand rear wheel well area.
w
5. Replace valve cover seal
CAMSHAFT / CARRIER REMOVAL
NOTE
The camshafts can be removed with the engine
installed in the chassis.
1. Rotate the engine so the piston is at Top Dead Center
(TDC) on the compression stroke.
NOTE
To verify TDC, see
Setting TDC (Top-Dead-Center), page
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.
2. Remove the hydraulic cam chain tensioner
q
.
3. Remove the camshaft sprocket bolt
if oil leaks are evident.
ENGINE / COOLING SYSTEM
the cylinder. Replace the sealing washer
reassembly.
engine from turning. Pull the camshaft sprocket
of the camshaft and remove the timing chain from the
sprocket. Carefully remove the camshaft from the
engine.
e
from
r
upon
3
u
while holding
i
off
3.65