Mitsubishi Electric GOT2000 Series Connection Manual page 302

(2) Ethernet connection type: EtherNet/IP (AB Tag)
This section describes the Ethernet setting for the
communication driver AB Control/CompactLogix (Tag).
Item
The host is displayed. (The host is
Host
indicated with an asterisk (*).)
Set the network No. of the connected
N/W No. Ethernet module.
(Default: blank)
Set the station No. of the connected
*1
Ethernet module.
Station
(Default: blank)
Type AB (Tag) (fixed)
Set the IP address of the connected
IP Address Ethernet module.
(Default: blank)
Port No. 44818 (fixed)
Communication TCP (fixed)
Connection setup
Connection
(Default: UCMM)
Set the slot No. of the PLC to which
Slot No. the Ethernet module is connected.
(Default: blank)
*1 Each of [GOT Station] set in the communication detail setting
and [Station] set in the Ethernet setting must be set to
different station numbers.
■
Communication detail settings
10 - 18
10. CONNECTION TO ALLEN-BRADLEY PLC
10.3 Ethernet Connection
Description Range
1 to 239
1 to 64
AB (Tag) (fixed)
PLC side IP
address
44818 (fixed)
TCP (fixed)
UCMM
Class3
0 to 20
POINT POINT POINT
Ethernet setting for the multiple CPU system
configuration
When Ethernet connection type is EtherNet/IP (AB
Tag), even if the device has the same IP address in
the Ethernet setting, the GOT can monitor in the
multiple CPU system configuration by setting different
slot Nos.
See the Ethernet setting in the following system
configuration.
(Example of system configuration)
Slot
Slot No.0 CPU
IP address: 1.1.1.1
Slot No.1 CPU
IP address: 1.1.1.1
(Example of Ethernet setting)
―
In the above mentioned Ethernet setting, the GOT
monitors the CPU as follows.
• When [Net No.]: 1 and [Station No.]: 1 are set for an
object, the GOT monitors the CPU whose slot No. is
0.
• When [Net No.]: 1 and [Station No.]: 2 are set for an
object, the GOT monitors the CPU whose slot No. is
1.
0 1
HUB
GOT
Net No.: 1
IIP address: 1.1.1.2