Mitsubishi Electric GOT2000 Series Connection Manual page 159

(2) Setting for the built-in MP2300S Ethernet and 218IF-
02
Item
IP Address
Transmission
Subnet Mask
parameter
Gateway IP Address
setting
Device name
Engineering Port
Transmission
parameter
Response Time
detailed setting
Count of Retry
(Number of Retries)
Connection Number
Local Port
*1
Node IP Address
Message
*1
Node Port
communication
of connection
Connection Type
parameter
setting
Protocol Type
Code
Node Name
*1 Set the same the Node IP Address (Remote Station's IP
Address) and the Node Port (Remote Station's Port Number)
as the Local IP Address and the Local Port (Local Station's
Port Number) on the GOT side.
For the Local IP Address and the Local Port (Local Station's
Port Number) on the GOT side, refer to the following.
6.3.4 ■ Ethernet setting
Set value Range
PLC side IP
[ ].[ ].[ ].[ ]
address
[ ].[ ].[ ].[ ]
PLC side setting
[ ].[ ].[ ].[ ]
Up to 16 one-byte
Arbitrary
characters
For a connection
256 to 65535 with software
MPE720
0
Not required for
communication
0
with GOT
• Range of built-
in MP2300S
Ethernet: 1 to 4
1
• Range of
218IF-02: 1 to
20
10500 256 to 65534
IP address
[ ].[ ].[ ].[ ]
of GOT
Port No.
[ ]
of GOT
UDP
TCP/UDP
(recommended)
Extended
MEMOBUS,
Extended MEMOBUS,
MEMOBUS MELSEC,
None,
MODBUS/TCP
BIN RTU, BIN, ACII
Up to 32 one-byte
characters
Arbitrary
(16 two-byte
characters)
6. CONNECTION TO YASKAWA PLC
6.3 Ethernet Connection
6
6 - 25