Mitsubishi Electric GOT2000 Series Connection Manual page 150

(For GT21,GS)
Item
Set this item when change the
transmission speed used for
Transmission
communication with the connected
Speed
equipment.
(Default: 19200bps)
Set this item when change the data
length used for communication with
Data Bit
the connected equipment.
(Default: 8bit)
Specify the stop bit length for
Stop Bit communications.
(Default: 1bit)
Specify whether or not to perform a
parity check, and how it is performed
Parity
during communication.
(Default: Even)
Set the number of retries to be
performed when a communication
Retry
error occurs.
(Default: 0time)
Specify the time period from the GOT
startup until GOT starts the
Startup Time
communication with the PLC CPU.
(Default: 3sec)
Set the time period for a
Timeout Time communication to time out.
(Default: 3sec)
Specify the host address (station No.
of the PLC to which the GOT is
Host Address connected) in the network of the
GOT.
(Default: 1)
Set this item to adjust the
transmission timing of the
Delay Time communication request from the
GOT.
(Default: 0ms)
Select the steps to store two words
32 bit Storage (32-bit data).
(Default: Auto)
6 - 16
6. CONNECTION TO YASKAWA PLC
6.2 Serial Connection
Description Range
4800bps,
9600bps,
19200bps,
38400bps,
57600bps
8bit (fixed)
1bit (fixed)
Even (fixed)
0 to 5times
3 to 30sec
1 to 30sec
1 to 31
0 to 30
( 10ms)
LH Order/ HL
Order/ Auto
POINT POINT POINT
(1) Delay Time
When connecting to PLC CP-9200(H) and CP-
9300MS, set the following.
Model name
CP-9200(H)
port:0
CP-9300MS
port:1
(2) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
Delay Time
30ms or more
10ms or more
30ms or more