Mitsubishi Electric GOT2000 Series Connection Manual page 296

(3) AB Control/CompactLogix
Item
Set this item when change the
transmission speed used for
Transmission
communication with the connected
Speed
equipment.
(Default: 19200bps)
Set this item when change the data
length used for communication with
Data Bit
the connected equipment.
(Default: 8bits)
Specify the stop bit length for
Stop Bit communications.
(Default: 1bit)
Specify whether or not to perform a
parity check, and how it is performed
Parity
during communication.
(Default: None)
Specify the format in which the sum
check is performed during
Sum Check Type communication when performing sum
check.
(Default: BCC)
Set the number of retries to be
performed when a communication
Retry
error occurs.
(Default: 3times)
Set the time period for a
Timeout Time communication to time out.
(Default: 3sec)
Specify the adapter address (station
No. of the PLC that the GOT will
Adapter Address
monitor) in the connected network.
(Default: 0)
Specify the host address (station No.
of the adapter to which the GOT is
Host Address
connected) in the connected network.
(Default: 0)
Set this item to adjust the
transmission timing of the
Delay Time communication request from the
GOT.
(Default: 0ms)
10 - 12
10. CONNECTION TO ALLEN-BRADLEY PLC
10.2 Serial Connection
Description Range
9600bps,
19200bps,
38400bps,
57600bps
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
BCC,
CRC16
0 to 5times
3 to 30sec
0 to 254
0 to 254
0 to 300ms
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.