Table of Contents
Advertisement
7.9. DISASSEMBLING THE TREAD-BELT MOTOR
Figure 7.9-1
Figure 7.9-2
Figure 7.9-3
Page 7.10
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
Carry out the procedure described in paragraph
7.7. "Disassembling the motor guard".
1. Raise the machine to an incline of
approximately 5%.
2. Turn off the machine and unplug the mains
lead from the wall outlet.
3. Unscrew the 4 nuts a which fix the belt
motor to the machine frame using a 13-mm
wrench.
4. Unscrew the 2 outer nuts b and the 2 inner
nuts c using a 13-mm wrench.
5. Move the TREAD BELT MOTOR toward
the driving roller.
6. Unscrew the screw d using a small Phillips
screwdriver.
7. Remove the cover and disconnect the cables
coming from the belt motor.
8. Lift up the motor.
9. Disengage the motor belt.
10. Remove the BELT MOTOR.
To reassemble the BELT MOTOR, carry out the
above steps in reverse order.
When reassembling, lock down screws a
and b using a torque wrench with a
setting of 13 Nm / 9.6ftlbs.
When reassembling the TREAD BELT
MOTOR, be careful to fit the plastic
components which assure its isolation
from the floor.
Continued on the following page →
Advertisement
Table of Contents
