Configuring Fcoe - Qlogic FastLinQ 3400 Series User Manual

9–Fibre Channel Over Ethernet

Configuring FCoE

To avoid any of the above error messages, it is necessary to ensure that there is
no USB flash drive attached until the setup asks for the drivers. Once you load the
drivers and see your SAN disk(s), detach or disconnect the USB flash drive
immediately before selecting the disk for further installation.
Configuring FCoE
By default, DCB is enabled on QLogic 8400 Series FCoE-, DCB-compatible
C-NICs. QLogic 8400 Series FCoE requires a DCB-enabled interface. For
Windows operating systems, use the QCC GUI or QLogic's Comprehensive
Configuration Management (CCM) utility to configure the DCB parameters.
151 83840-546-00 E