Windows Driver Software; Installing The Driver Software - Qlogic FastLinQ 3400 Series User Manual

4

Windows Driver Software






NOTE

Installing the Driver Software

NOTE
When Windows first starts after a hardware device has been installed (such as a
QLogic 8400/3400 Series adapter), or after the existing device driver has been
removed, the operating system automatically detects the hardware and prompts
you to install the driver software for that device.
Installing the Driver Software
Removing the Device Drivers
Installing QLogic Management Applications
Viewing or Changing the Adapter Properties
Setting Power Management Options
QLogic now supports QConvergeConsole GUI as the only GUI management
tool across all QLogic adapters. The QLogic Control Suite (QCS) GUI is no
longer supported for the 8400/3400 Series Adapters and adapters based on
57xx/57xxx controllers, and has been replaced by the QCC GUI
management tool. The QCC GUI provides single-pane-of-glass GUI
management for all QLogic adapters.
In Windows environments, when you run the QCS CLI and the Management
Agents Installer, it will uninstall the QCS GUI (if installed on the system) and
any related components from your system. To obtain the new GUI, download
QCC GUI for your adapter from the QLogic Downloads Web page:
driverdownloads.qlogic.com
These instructions assume that your QLogic 8400/3400 Series adapter was
not factory installed. If your controller was installed at the factory, the driver
software has been installed for you.
17 83840-546-00 E