Qlogic FastLinQ 3400 Series User Manual page 148

9–Fibre Channel Over Ethernet
FCoE Boot from SAN
3. Ensure DCB/DCBX is enabled on the device
supported on DCBX capable configurations. As such, DCB/DCBX must be
enabled, and the directly attached link peer must also be DCBX capable with
parameters that allow for full DCBX synchronization.
Figure 9-2. FCoE Boot<Variable>—Enable DCB/DCBX
4. On some platforms, you may need to set the boot protocol through system
BIOS configuration in the integrated devices pane as described above.
For all other devices, set the Boot Protocol field to FCoE in the MBA
Configuration Menu
Figure 9-3. FCoE Boot<Variable>—Select FCoE Boot Protocol
(Figure 9-3) through CCM.
120
(Figure 9-2). FCoE boot is only
83840-546-00 E