Qlogic FastLinQ 3400 Series User Manual page 104

8–iSCSI Protocol
iSCSI Boot
5. In the 1st Target Parameters menu, enable Connect to connect to the iSCSI
target. Type values for the following parameters for the iSCSI target, and
then press ENTER:






6. Press ESC to return to the iSCSI Boot Main menu.
7. If you want configure a second iSCSI target device, select 2nd Target
Parameters, and enter parameter values as you did in
proceed to
8. Press ESC once to return to the Main menu, and a second time to exit and
save the configuration.
9. Select Exit and Save Configurations to save the iSCSI boot configuration
(Figure
ENTER.
Figure 8-7. Saving the iSCSI Boot Configuration
10. After all changes have been made, press CTRL+ALT+DEL to exit CCM and
to apply the changes to the adapter's running configuration.
NOTE
In NPAR mode, ensure that the iSCSI function is configured on the first
Physical Function (PF) for successful boot from SAN configuration.
IP Address
TCP Port
Boot LUN
iSCSI Name
CHAP ID
CHAP Secret
Step 8.
8-7). Otherwise, select Exit and Discard Configuration. Press
76
Step 5. Otherwise,
83840-546-00 E