Event Log Messages; Windows System Event Log Messages; Base Driver (Physical Adapter/Miniport) - Qlogic FastLinQ 3400 Series User Manual

15–QLogic Teaming Services

Event Log Messages

Event Log Messages


Windows System Event Log Messages



Base Driver (Physical Adapter/Miniport)


Intermediate Driver (Virtual Adapter/Team)

Virtual Bus Driver
Windows System Event Log Messages
The known base and intermediate Windows System Event Log status messages
for the QLogic 8400/3400 Series adapters are listed in
As a QLogic adapter driver loads, Windows places a status code in the system
event viewer. There may be up to two classes of entries for these event codes
depending on whether both drivers are loaded (one set for the base or miniport
driver and one set for the intermediate or teaming driver).
Base Driver (Physical Adapter/Miniport)
The base driver is identified by source L2ND.
messages supported by the base driver, explains the cause for the message, and
provides the recommended action.
NOTE
In
NDIS 6.x drivers, message numbers 18 through 23 apply only to the NDIS
6.x driver.
Message
Severity
Number
1 Error
2 Error
Table 15-7, message numbers 1 through 17 apply to both NDIS 5.x and
Table 15-7. Base Driver Event Log Messages
Message
Failed to allocate
memory for the
device block. Check
system memory
resource usage.
Failed to allocate
map registers.
Table 15-7
Cause
The driver cannot allo-
cate memory from the
operating system.
The driver cannot allo-
cate map registers from
the operating system.
224
Table 15-7 and Table
lists the event log
Corrective Action
Close running applica-
tions to free memory.
Unload other drivers
that may allocate map
registers.
83840-546-00 E
15-8.