Qlogic FastLinQ 3400 Series User Manual page 260

15–QLogic Teaming Services
Event Log Messages
Table 15-9. VBD Event Log Messages (Continued)
Message
Severity
Number
9 Informational
10 Error
11 Error
12 Informational
13 Error
14 Error
15 Error
Message
Network controller
configured for 1Gb
full-duplex link.
Unable to register the
interrupt service rou-
tine.
Unable to map IO
space.
Driver initialized suc-
cessfully.
Driver initialization
failed.
This driver does not
support this device.
Upgrade to the latest
driver.
This driver fails initial-
ization because the
system is running out
of memory.
232
Cause
The adapter has been
manually configured
for the selected line
speed and duplex set-
tings.
The device driver can-
not install the interrupt
handler.
The device driver can-
not allocate mem-
ory-mapped
I/O to access driver
registers.
The driver has suc-
cessfully loaded.
Unspecified failure
during driver initializa-
tion.
The driver does not
recognize the installed
adapter.
Insufficient system
memory prevented the
initialization of the
driver.
Corrective Action
No action is required.
Reboot the operating
system; remove other
device drivers that
may be sharing the
same IRQ.
Remove other adapt-
ers from the system,
reduce the amount of
physical memory
installed, and replace
the adapter.
No action is required.
Reinstall the driver,
update to a newer
driver, run QCC GUI
diagnostics, or replace
the adapter.
Upgrade to a driver
version that supports
this adapter.
Increase system mem-
ory.
83840-546-00 E