Table of Contents
Advertisement
9–Fibre Channel Over Ethernet
FCoE Boot from SAN
Windows Server 2008 R2 and Windows Server 2008 SP2
FCoE Boot Installation
Ensure that no USB flash drive is attached before starting the OS installer. The
EVBD and OFC/BXFOE drivers need to be loaded during installation. Go through
the normal procedures for OS installation. When no disk devices are found,
Windows will prompt you to load additional drivers. At this point, connect a USB
flash drive containing the full contents of the provided EVBD and OFC boot driver
folders. After all appropriate drivers are loaded, the setup show the target disk(s).
Disconnect the USB flash drive before selecting the disk for installation.
1.
Load the EVBD driver first
(Figure
Figure 9-11. Load EVBD Driver
128
9-11).
83840-546-00 E
Advertisement
Table of Contents
Troubleshooting
